But when I try and resync any clients I get "The computer did not resync because no time data was available. I'm assuming from that the NTPServer is not actually running. Any help would be greatly appreciated. For detailed analysis, you could perform a network capture. From the packets, you would find out if the requests are sent or not. And if the server responded or not. Please remember to mark the replies as answers if they help and unmark them if they provide no help.
If you have feedback for TechNet Support, contact tnmff microsoft. I did change the name of the requesting server in the above list to use its IP address just to remove any personal system information. I still got the same response on the client server "The computer did not resync because no time data was available". I'm afraid I could not find any document about the configuration. I suppose your configuration is correct. Have you tried to sync from another server not running Server ? Office Office Exchange Server.
Not an IT pro? SQL Server. What is the maximum cable length of the GPS antenna? GPS signal issues. What is Galileo? DCF Timing Advantages. What is the coverage of the MSF signal? What is the coverage of the DCF signal? Where is the best place to locate a MSF radio antenna? Where is the best place to locate a DCF radio antenna?
What is the maximum cable length of the MSF radio antenna? What is the maximum cable length of the DCF radio antenna? What are SysLog messages? How are the Digital Wall Clocks configured? The X's can be the IP address of the time server or the domain name of a time server such as time-a. Next you need to sync all of your client PC's to the domain controller. You can do the following from the command line. You can remotely do these commands using psexec from SysInternals if you have a lot of client machines.
I want to use the internal clock on the server as my clock. I have changed the status to Manual, but it is not finding the internal time. I get a message that it could not resync becuase no time date was available after I restarted. How do I get my remaining servers to get the time from the PDC? I have set up the PDC with the information above, but unsure how then re-sync the remaining forest servers to use the PDC and the primary time source.
If I am not mistaken there are Group Policy Objects that you can push these settings out with to the rest of your servers. I'm trying to remember but I'm pretty sure a server that is joined to the domain automatically tries to sync with the PDC. The problem is that some of the servers have been set up differently over the years due to legacy and these now point to different NTP servers I know not the best of practices , and not at the PDC.
Manage Preferences. Home Questions. Jagadeshan 13 years ago.
0コメント